AMX Control Module for: MTX5-D Matrix Processor Rev.1
2
Introduction
The MTX5-D can be controlled via Ethernet or RS232 using
our Serial Control Protocol (SCP). The MTX5-D supports up
to nine remote control connections at once.
In MTX Editor, if you go to System > Remote Control you
will see the two types of remote connection listed. One will be
a TCP/IP socket on port 49280. The other will be an RS232
port (congurable to be either 38400 baud or 115200 baud).
The RS232 pinout for the MTX5-D is Rx 2, Tx 3, Gnd 5.
For an AMX system, that means pins 2 and 3 are crossed. Do
not connect any other pins – it may stop the communication
from owing. The full pinout (and AMX FG number for their
pre-made cables) are here:
Remote Control Connector Information
Cable FG Number: 10-756-10
9 Pin D Sub Female
(AMX 41-0903 WITH
AMX 41-0902 HOOD)
Function Note
Customer must provide the 9 pin connector (female housing, female pins)
that is supplied with the lens.
AMX doesn’t currently carry this connector.
9 Pin D Sub Female
(AMX 41-0903 WITH
AMX 41-0902 HOOD)
Revision
Rev 1
Legend
GND = Ground
RXD = Receive Data
TXD = Transmit Data
Connector Type
9 Pin D-Sub, Female
Type of Control
RS-232
2 RXD
3 TXD
5 GND
RED
WHT
BLK
TXD 3
RXD 2
GND 5
Revision
Rev 1
Legend
GND = Ground
RXD = Receive Data
TXD = Transmit Data
Cable length
10 Feet
Legend
GRND = Ground
TXD = Transmit Data
RXD = Receive Data
Type of Control
RS-232
Supported AMX Devices
AXCENT3 RS232 PORT
Revision
Rev 1
Legend
GND = Ground
RXD = Receive Data
TXD = Transmit Data
Cable length
10 Feet
Legend
GRND = Ground
TXD = Transmit Data
RXD = Receive Data
Type of Control
RS-232
Supported AMX Devices
AXCENT3 RS232 PORT
NETLINX Connections
4 Pin Female Phoenix
(P/N AMX 41-5047)
9 Pin D Sub Female
(AMX 41-0903 WITH
AMX 41-0902 HOOD)
1 GND
2 RXD
3 TXD
PIN 1
PIN4
BLK
RED
WHT
GND 5
TXD 3
RXD 2
Remote Control Connector Information
Cable FG Number: 10-756-04
To Next Page
Loading...
