8-11
8
To install the spark plug
1. Clean the surface of the spark plug gasket
and its mating surface, and then wipe off any
grime from the spark plug threads.
2. Install the spark plug with the spark plug
wrench, and then tighten it to the specified
torque.
If a torque wrench is not available when installing
the spark plug, a good estimate of the correct
torque is 1/4–1/2 turn past finger tight. However,
the spark plug should be tightened to the speci-
fied torque as soon as possible.
3. Install the spark plug cap.
EBU37000
Engine oil
The engine oil level should be checked before
each ride. In addition, the oil must be changed at
the intervals specified in the periodic maintenance
and lubrication chart.
To check the engine oil level
1. Place the ATV on a level surface.
2. Check the engine oil level on a cold engine.
If the engine was started before checking the oil
level, warm up the engine and then wait at least
ten minutes until the oil settles for an accurate
reading.
3. Remove the engine oil filler cap, and then
wipe the engine oil dipstick off with a clean
rag.
Tightening torque:
Spark plug:
12 N·m (1.2 kgf·m, 8.7 lb·ft)
1. Engine oil filler cap
UBD372E0.book Page 11 Wednesday, February 1, 2017 10:29 AM
To Next Page
Loading...
Need help?
General
