Yamaha SR125 - Carburetor Adjustment; Idle Speed Adjustment

PERIODIC MAINTENANCE AND MINOR REPAIR
6-11
6
EAU00629
Carburetor adjustment
The carburetor is a vital part of the en-
gine and requires very sophisticated
adjustment. Most adjustments should
be left to a Yamaha dealer who has the
professional knowledge and experi-
ence to do so. However, the following
may be serviced by the owner as part
of routine maintenance.
EC000094
CAUTION:
@
The carburetor was set at the
Yamaha factory after many tests. If
the settings are changed, poor en-
gine performance and damage may
result.
@
EAU01168
Idle speed adjustment
NOTE:
@
A diagnostic tachometer must be used
for this procedure.
@
1. Attach the tachometer. Start the
engine and warm it up for a few
minutes at approximately 1,000 to
2,000 r/min. Occasionally rev the
engine to 4,000 to 5,000 r/min.
The engine is warm when it quick-
ly responds to the throttle.
2. Set the idle to the specified engine
speed by adjusting the throttle
stop screw. Turn the screw in di-
rection
a
to increase engine
speed and in direction
b
to de-
crease engine speed.
NOTE:
@
If the specified idle speed cannot be
obtained by performing the above ad-
justment, consult a Yamaha dealer.
@
1. Throttle stop screw
Standard idle speed:
1,300 ~ 1,400 r/min
E_3mw.book Page 11 Monday, February 5, 2001 9:54 AM