No-Wake Mode can be engaged when
the throttles are at idle speed in
Forward, Neutral, or Reverse. Engine
speed will be set at 2400 rpm for con-
venient, no-wake maneuvering.
To set No-Wake Mode:
Press both gray No-Wake Mode but-
tons simultaneously until the three
symbols in each tachometer start blink-
ing.
NOTE: Although each engine is con-
trolled separately, always put both
engines in No-Wake Mode for proper
operation.
To cancel the No-Wake Mode, do any
of the following:
Press both No-Wake Mode buttons
again.
Move the accelerator levers to a faster
engine speed.
Shut off the engines with the key or by
using the engine stop switch lanyard.
Once the engines have stopped, you
have NO STEERING CONTROL over
the boat. You could collide with
another boat, a dock, or other obsta-
cle.
Accessory Outlet
There is a 12VDC outlet with resettable
circuit breaker located on the main
switch panel.
Do not use an automotive cigarette
lighter or other accessories with a
plug that gets hot because the outlet
can be damaged.
Switch Circuit Breakers
The electrical circuit for each switch is
protected by a circuit breaker. If the but-
ton below a switch pops out, push it
back in with your finger. If it pops out
again, ask your Yamaha dealer to
inspect the electrical system.
FEATURES & FUNCTIONS 2
2-15
12 VDC
BREAKER
To Next Page
Loading...
