NOTE: Before the first start-up, remove
the fuel tank filler cap to release any
built-up pressure in the tank because of
fuel expansion.
2) Attach the engine shut-off cord to
your PFD. Install the cord clip onto
the engine shut-off switch by push-
ing the clip groove over the nut
beneath the knob. Be sure the cord
is not wrapped around the steering
wheel or tangled in the controls.
Engine shut-off switch
Clip with cord
NOTE: It is not possible to start the
engine with the clip removed from the
engine shut-off switch. However, the
starter motor will turn the engine over.
3) Put the control levers in the Neutral
position. Turn the ignition key of one
engine to “Start.” When the engine
starts, release the key. Repeat for
the other engine.
3 OPERATION
To Next Page
Loading...
