* The M-size eartips are attached.
Silicone Sleeve (S, M) 1 set each
* The S-size silicone sleeves are attached.
USB power cable
Startup Guide
User’s Guide (Basic) (this manual)
Safety Brochure
Preparation
B. Charging
To charge the charging case and earphones, connect the included USB power cable to the charging
connector on the charging case and to the USB port on a commercially available USB power adaptor (5
V DC/min. 0.5 A output).
The indicator is lit in orange during charging and goes off when charging is completed.
Charging takes about two hours. When charged, the earphones can play back continuously for
approximately 6 hours.
C. Making a Bluetooth® connection
When using the earphones for the first time, the pairing process, which allows Bluetooth devices being
connected to detect each other, must be performed. Once paired, the Bluetooth devices will be
automatically connected the next time they are turned on.
■ Pairing
1. Remove the right earphone from the charging case.
* The indicator on the right earphone flashes alternately in blue and red, and the earphone enters
pairing standby mode.
2. Remove the left earphone from the charging case.
3. Operate the connected Bluetooth device to display the Bluetooth setting screen.
4. Select “Yamaha TW-E3A R” from the displayed screen.
* When pairing has completed, the indicator lights up in blue for 20 seconds.
* If pairing has not completed within two minutes, it will be considered to have failed, and the
indicator goes off.
To try pairing again, turn the earphones off, then on again.
■ Registering another Bluetooth device/ Perform pairing operations again
For details about paring, refer to the this website.
■ Turning on
Remove the earphones from the charging case. Otherwise, press the function key on each earphone
(left and right) for two seconds.
To Next Page
Loading...
