Operation
45
few minutes. Otherwise fuel may leak.
CAUTION:
ECM00241
●
Before tilting the outboard motor, stop
the engine by following the procedure
on page 42. Never tilt the outboard mo-
tor while the engine is running. Severe
damage from overheating can result.
●
Do not tilt up the engine by pushing the
tiller handle (if equipped) because this
could break the handle.
EMU28007
Procedure for tilting up (power trim
and tilt models / power tilt models)
1. Place the remote control lever / gear
shift lever in neutral.
2. Disconnect the fuel line from the out-
board motor or close the fuel cock.
3. Press the power trim and tilt switch /
power tilt switch “” (up) until the out-
board motor has tilted up completely.
4. Push the tilt support knob into the clamp
bracket or pull the tilt support lever to-
ward you to support the engine.
WARNING
EWM00260
After tilting the outboard motor, be sure
to support it with the tilt support knob or
tilt support lever. Otherwise the outboard
motor could fall back down suddenly if oil
in the power trim and tilt unit loses pres-
N
ZMU03196
UP
ZMU01954
ZMU01886
To Next Page
Loading...
Need help?
General
