Name: Yamaha XLT800 WaveRunner 2002
Brand: Yamaha
Rating: 4 (1 reviews)

To Next Page

To Previous Page

5-6

EJU01121

Connecting the jumper cables

1. Connect the positive (+) jumper cable 1

to the positive (+) terminals of both bat-

teries.

2. Connect one end of the negative (–)

jumper cable 2 to the negative (–) termi-

nal of the booster battery 3.

3. Connect the other end of the negative (–)

cable to an unpainted bolt on the cylinder

head.

CAUTION:

Do not connect the end of the jumper

cable to the negative (–) terminal on the

watercraft battery! Be sure all connec-

tions are secure and correct before

attempting to start the engine. Any

wrong connection may damage the elec-

trical system.

4. Start the engine, and then disconnect

the cables by reversing the steps above.

CAUTION:

●

Never push the start switch while the

engine is running.

●

Do not operate the start switch for

more than 5 seconds, otherwise the

battery will be discharged and the

engine will not start. Also, the starter

motor may be damaged. If the engine

does not start in 5 seconds, release

the start switch, wait 15 seconds, and

try again.

UF1F10.book Page 6 Monday, September 3, 2001 9:26 AM

Questions and Answers:

Need help?

Do you have a question about the Yamaha XLT800 WaveRunner 2002 and is the answer not in the manual?

Yamaha XLT800 WaveRunner 2002 Specifications

General