8 - 41
CHAS
●
Install the new bearings.
OTE:
Install the outside bearing first.
CAUTION:
Do not strike the center race or balls of the
bearing. Contact should be made only with
the outer race.
●
Install a new oil seal.
OTE:
When installing the oil seals, the “seal side” of
the oil seal faces out.
*****************************************************
INSTALLING THE TIE ROD
1.Install:
●
Tie rods (left and right)
OTE:
The tie rod which must be installed on the out
side has grooves 1.
T
R
.
.
30 Nm (3.0 m • kg, 22 ft • lb)
2.Adjust:
●
Toe-in
Refer to “ADJUSTING THE TOE-IN” in
CHAPTER 3.
STEERING SYSTEM
To Next Page
Loading...
