Need help?Do you have a question about the Yamaha YFZ 50 and is the answer not in the manual?
General| Brand | Yamaha |
|---|---|
| Model | YFZ 50 |
| Category | Offroad Vehicle |
| Language | English |
Emphasizes the importance of reading the manual for safety information.
Highlights critical safety instructions and recommendations for ATV operation.
Explains symbols and terms used to denote hazards and important information.
Specifies that the ATV is designed exclusively for off-road use and not for public roads.
Details how to find and record VIN, model, and key identification numbers.
Illustrates the placement of various warning and specification labels on the ATV.
Displays critical warnings regarding age restrictions and safe operation practices.
Covers essential safety rules for ATV operation, including age, training, and protective gear.
Identifies key components of the ATV from left and right side perspectives.
Illustrates and labels the primary controls located on the handlebars.
Explains the function of the main switch and its ON/OFF positions.
Details the operation of the engine stop switch, start switch, and lanyard.
Describes how to adjust the speed limiter to control engine power and maximum speed.
Explains how to operate the front and rear brake levers and the parking brake.
Details the procedure for using the kickstarter to start the engine.
Provides instructions for safely removing and securing the fuel tank cap.
Specifies the recommended fuel type, octane, tank capacity, and reserve amount.
Explains the functions of the fuel cock lever: OFF, ON, and RES.
Describes the starter (choke) lever for enriching the air-fuel mixture for cold starts.
Details seat removal and rear shock preload adjustment.
Lists checks for fuel, oil, transmission oil, and brake operation.
Covers checks for tires, drive chain, controls, and fasteners.
Provides a step-by-step guide for starting the engine when it is cold.
Covers starting procedures for a warm engine and the critical engine break-in period.
Details safe parking procedures, especially when on inclines.
Offers advice on selecting and mounting accessories to maintain safe operation.
Introduces the rider to the ATV and emphasizes familiarization before riding.
Covers essential riding practices like training, speed, and terrain awareness.
Lists required protective gear, including helmets, eye protection, and clothing.
Stresses pre-operation checks and prohibits operating under the influence of alcohol or drugs.
Warns against riding on paved surfaces due to compromised handling and control.
Explains proper techniques for turning the ATV safely at various speeds.
Provides guidelines for climbing hills, emphasizing weight shift and terrain assessment.
Details safe downhill riding, including weight shift and braking techniques.
Instructs on how to traverse slopes, maintain balance, and handle potential tip-overs.
Provides instructions for safely crossing shallow water, including brake testing.
Offers advice for riding over rough terrain and obstacles, emphasizing caution.
Explains how to control skidding and sliding, and practice techniques safely.
Offers solutions for common riding issues like non-turning, tipping, sliding, or hill climbing failure.
Emphasizes the importance of regular maintenance for safety and performance.
Instructs where to store the owner's manual and tool kit.
Details the maintenance schedule for emission control components.
Outlines the schedule for general maintenance tasks and lubrication points.
Explains how to remove body panels and check the spark plug condition.
Details procedures for checking and changing engine and transmission oil.
Explains how to clean the air filter element and spark arrester.
Covers carburetor, throttle lever, and brake adjustments.
Details drive chain slack adjustment and chain cleaning/lubrication.
Covers battery safety, removal, installation, and fuse replacement.
Details the procedures for removing and installing the ATV wheels.
Offers guidance for diagnosing and resolving common operational issues.
A visual guide to diagnose starting problems related to fuel, battery, ignition, and compression.
Provides comprehensive steps for cleaning the ATV to maintain its appearance and performance.
Details instructions for storing the ATV for short and extended periods, including fuel stabilization.
Lists the physical dimensions, weight, and loading capacity of the ATV.
Details recommended engine oil grades, fuel capacity, and brake types.
Explains the purpose and location of the emission control information label.
Outlines noise control regulations and prohibits tampering with related systems.
Provides a table to log scheduled maintenance intervals and services performed.
Details the terms, conditions, exclusions, and duration of the ATV's limited warranty.
Addresses common warranty questions and provides customer service contact information.
Describes the advantages and coverage options of the Yamaha Extended Service plan.
To Next Page
