Need help?Do you have a question about the Yamato 302 and is the answer not in the manual?
Ensures safe starting by verifying components like fuel, oil, steering, and spark plugs are correctly set.
Detailed steps for initiating the motor, including fuel settings, choke usage, and rope pulling.
Addresses issues preventing the hull from planing, involving checks of transom, propeller, and motor performance.
Guidance on observing motor performance during use, including timing, throttle, and listening for unusual noises.
Methods for safely shutting down the engine using the throttle lever or kill-switch.
Instructions for cleaning and maintaining the motor after use, including flushing salt water and drying components.
Procedures for retrieving and drying a motor that has been submerged in water to prevent further damage.
Step-by-step guide to dismantling the power unit, covering removal of magneto, carburetor, and cylinder block.
Procedures for checking power unit components like cylinder walls, crankshaft, and bearings for wear or damage.
Instructions for reassembling the power unit, emphasizing correct lubrication, bearing seating, and torque application.
Guide to taking apart the magneto assembly, involving removal of the starter pulley, key, and flywheel components.
Steps for reassembling the magneto, including correct timing, lubrication, and tightening of the flywheel nut.
Technical details for the magneto, including ignition timing settings and spark plug gap requirements.
Procedure for dismantling the carburetor, covering the removal of the float cover, nut, banjo, and float assembly.
Checks for the carburetor's float needle, its contact point, and all internal passageways and jets for obstructions.
Instructions for reassembling the carburetor, including throttle butterfly check and float level adjustment.
Steps for taking apart the gear case, including removal of the tail cap, propeller shaft, and internal gears.
Methods for inspecting the gear case, checking oil for water, gear wear, and bearing condition.
Guidance on reassembling the gear case, including bearing installation, shim adjustment, and filling with gear oil.
To Next Page
General