61
11. ACCESSORY OPTIONS
Accessory Item List
Table 11.2 List of options (factory installation required)
Termmal allowing a signal,
indicating “END” of Auto Stop
Operation or Programmed
Operation, to be ouput externally.
Operation Signal Output
Terminal
Terminal allowing signal,
indicating operation in progress,
to be output externally.
Terminal allowing ON-OFF
signals, indicating unit status,
such as standby, operating,
operation end, and program
steps, to be output externally.
Button to shut main power off in
the event of an emergency.
Integrated into main unit.
Paperless (inputs: 6), sensor
optional (may be used with
ODT48). The following three
parameters may be monitored:
temperature as measured by unit
main controller (PV), objective
temperature while in operation
(SV), heater output ratio (MV).
10m substitution power cable for
main unit.
Electronic damper allowing
exhaust port aperture and air flow
to be controlled automatically by
motor and control circuit in five
stages.
N2 gas injection unit (with
Unit allows N
2
gas to be routed
into chamber, preventing sample
oxidization during processing. N
2
gas flow may be monitored using
flow meter.
Exhaust port (O.D. 80mm) for
exterior duct installed on rear
panel prevents dust and other
contaminants from being expelled
into clean rooms. Duct and
external fan unit not included.
Hi-performance HEPA filter
Hi-performance filter maintains
clean level class 100 in all heating
conditions (stabilization, increase,
decrease).
Max resistance temp: 200℃.
To Next Page
