What to do if my Yamato Laboratory Equipment shows a sensor error?
If your Yamato Laboratory Equipment displays a sensor error, it could be due to an error in the temperature input circuit, a disconnection or other errors in the temperature sensor, or because the measured temperature is outside the displayable range. In any of these cases, you should contact our service department.
Why does my Yamato Laboratory Equipment show a memory error?
A memory error in your Yamato Laboratory Equipment indicates a memory setting error. In this case, you should contact our service department.
What to do if my Yamato Laboratory Equipment has a measured temperature error?
If your Yamato Laboratory Equipment indicates a measured temperature error, you should contact our service department.
What to do if turning the MCB on doesn't activate my Yamato IC103CW Accessories unit?
If turning the MCB to 'on' doesn't activate your Yamato Accessories unit, first ensure the power cord is securely connected. Then, check for any power outages in your area. Finally, verify that the standalone overheat prevention device is working correctly.
Why temperature does not rise in my Yamato IC103CW Accessories?
If the temperature isn't rising in your Yamato Accessories device, verify that the set temperature is higher than the current temperature inside the device. Also, check if the power supply voltage has declined. Ensure that the ambient temperature isn't too low and that the cooling load inside the chamber isn't excessively large.
What to do if temperature fluctuates during operation of my Yamato IC103CW Accessories?
If the temperature fluctuates during operation of your Yamato Accessories, check that the set temperature is appropriate for your needs. Also, verify the power supply voltage and ensure that the ambient temperature isn't fluctuating widely. Finally, make sure the cooling load inside the chamber isn't too large.
Why displayed temperature differs from the measurement on my Yamato Accessories?
If the displayed temperature differs from the actual measurement on your Yamato Accessories, the calibration offset setting might not be set to “0.” Set it to “0” to resolve this issue.
General| Brand | Yamato |
|---|---|
| Model | IC103CW |
| Category | Accessories |
| Language | English |
To Next Page
