Periodic Inspection
82
13. Checking the muffler
The muffler is designed with small holes
that may give out sparks and cause fire.
Check the muffler every 200 hours.
14. Checking the electrical wiring
● Remove the chaff and dust on the
battery and wiring before and after
operation to prevent fire.
● Check whether the electrical wire is in
contact with other parts, the coating
has peeled off or the connections are
loose, and repair in case of damage
15. Maintaining and adjusting the
cutter blades
Be sure to fix the safety lock of the header.
Otherwise, it may fall down rapidly and
cause injuries.
Do not touch the cutter blades during
maintenance or replacement to avoid
injury.
Adjust the gap between cutter blades if the
crops could not be cut off.
<Adjusting>
1- Raise the header to the highest position and fix it.
2- Adjust the upper and lower gaps between backing
edge and cutter blades by slightly hammering the
front end of shims or adding gasket to the loosened
nuts.
3- Adjust the front and rear gaps between blades by
loosening the fixing nuts and moving the friction plate
forward or backward.
Muffle
B
C
Cutter blade
su
ort
Friction plate
E
D
https://tractormanualz.com/yanmar/
To Next Page
Loading...