Yanmar i8350 - Appendix C: Default Settings; Engine Interface Configurations

Page 20 © Yanmar 2008
Electronic Control System:
Operation Manual for SY Series Engines with GEN III Controls
Appendix C
For single engine conguration, the engine interface part number is i8350 (no trolling) or i8355 (with trolling).
The settings are the same as the dual engine conguration below.
Without Trolling
Engine Interface part number i8350P i8350S
Idle RPM 600 600
Sync Cruise Cruise
Lead Engine Port* Port*
Split Range Throttle 25% 25%
Forward Throttle Curve F8 F8
Reverse Throttle Curve R1 R1
Programmable Shift Delay 9.6 9.6
Fixed Shift Delay 0.2 0.2
Station Select Protection Off Off
With Trolling
Engine Interface part number i8355P i8355S
Idle RPM 600 600
Sync Cruise Cruise
Lead Engine Port* Port*
Troll Trans Type ZF ZF
Troll Engage RPM 800 800
Split Range Throttle 25% 25%
Forward Throttle Curve F8 F8
Reverse Throttle Curve R1 R1
Programmable Shift Delay 9.6 9.6
Fixed Shift Delay 0.2 0.2
Station Select Protection Off Off
Troll Mode** Split Split
Troll Lever Travel 60% 60%
Maximum Throttle in Troll Mode 40% 40%
Troll Throttle Engage Delay 0.2 0.2
Note: A system reset may be needed for some changes to take effect.
*Only shows when Sync is set to Power Train
**Troll Mode functions are not displayed until Troll Mode is selected.