Need help?Do you have a question about the Yard force GM R40 and is the answer not in the manual?
General| Brand | Yard force |
|---|---|
| Model | GM R40 |
| Category | Lawn and Garden Equipment |
| Language | English |
Wear substantial footwear and long trousers. Do not operate barefoot or in open-toed sandals.
Refuel outdoors, do not smoke while refueling, add fuel before starting engine, or when hot.
Visually inspect blade, bolts, and assembly for wear or damage before use. Replace worn parts.
Do not operate in confined spaces. Mow in daylight. Avoid wet grass. Be sure of footing on slopes. Walk, not run.
Lists and identifies components of the lawnmower, such as upper handle, engine, and grass collection bag.
Verify all parts are present after unpacking, including main deck, handles, screws, and manual.
Attach the lower handle to the mower deck using screws and ensure proper alignment.
Connect the upper handle to the lower handle using fixing knobs and tensioning bolts.
Secure the control cables to the lower handle using the provided clips.
Attach the grass collection bag to the mower frame and ensure the safety flap is released.
Check and fill engine oil using SAE 30 or equivalent, ensuring level is between Min. and Max. marks.
Refuel outdoors in a well-ventilated area with the engine stopped, using unleaded petrol.
Adjust cutting height lever to one of five positions. Never use lowest for first cut or drought conditions.
Prime engine, pull start/stop bar, and pull starter cord. Follow procedures for cold/warm starts.
Observe safety procedures. Mow with grip on handle and start/stop bar. Mow across slopes, avoid steep slopes.
Allow engine to cool, empty grass bag, clean deck, store on flat surface in dry, safe place.
Empty fuel tank, run engine dry, change oil, coat cylinder with oil, clean fins, store in well-ventilated place.
Adhere to recommended schedule for cleaning, air filter, spark plug, and oil changes for optimal performance.
Keep machine clean and lubricated. Clear debris, do not use water jet or aggressive cleaners.
Remove cover, tap or replace filter. Ensure filter element is installed before running engine.
Remove, clean with wire brush, set gap to 0.7-0.8mm, and reinstall spark plug carefully.
Tilt mower, drain oil, refill with SAE 30 or 10W/30, checking level with dipstick.
Wear gloves, remove blade bolt and blade, inspect adaptor, fit new blade, tighten bolt securely.
To Next Page
