Yard Machines 588 User Manual

M4c,,.es)ff
OPERATOR'S MANUAL
Models
587 and 588
IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY
Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimpr'oved forest-
covered, brash-covered or grass-covered land unless the engine's exhaust system is equipped with a spark arrester meeting
applicable local or state laws (if any). If a spark arrester is used. it should be maintained in effective working order by the operator.
In the State of CaJifomie the above is required by law (Section 4442 of the California Public Resources Code). Other states may have
similar laws. Federal laws apply on federal lands. A spark attester for the muffler is available through your nearest engine authorized
service dealer or contact the service department, P.O. Box 368022 Cleveland, Ohio 44136-9722.
MTD PRODUCTS INC. P.O. BOX 368022 CLEVELAND, OHIO 44136-9722
PRINTED IN U.S.A. FORM NO. 770-10147
(8/98)

Yard Machines 588 Specifications

General

Brand	Yard Machines
Model	588
Category	Edger
Language	English

Summary

Important Safety Rules and Instructions

Finding Your Model Number

Calling Customer Support

Important Safe Operation Practices

Training and Preparation

Thoroughly read the manual, understand controls, and prepare the area for safe edger operation.

Blade Coasting Caution

Warning that the cutting blade continues to rotate after the engine is turned off.

Operator Responsibility Warning

Users are responsible for reading, understanding, and following all manual instructions and warnings.

Edger Set-Up Instructions

Edger Assembly Steps

Instructions for unfolding the handle, attaching the clutch rod, and securing components.

Clutch Rod Adjustment Procedure

Critical adjustment of the clutch rod to ensure the blade disengages properly.

Edger Controls Overview

Throttle Control Operation

How to use the throttle lever to start, stop, and control engine speed.

Blade Clutch and Depth Control

How to engage/disengage the blade and adjust the cutting depth using the control lever.

Blade Plane Adjustment

Adjusting the cutting blade angle from vertical to horizontal for different cutting tasks.

Edger Operation Guide

Starting the Engine

Step-by-step guide for safely starting the edger's engine, including choke and throttle use.

Stopping the Engine

Procedure for safely shutting down the edger's engine and preventing accidental starts.

Operating the Edger

Guidance on how to use the edger for edging, trenching, and trimming tasks.

Lubrication Instructions

Edger Maintenance

Engine Maintenance

Refer to the engine manual for specific engine care and maintenance procedures.

Blade Removal and Replacement

Instructions on how to remove and replace the cutting blade safely.

Belt Removal and Replacement

Steps for removing and replacing the V-belt, including belt guard removal.

Off-Season Storage Preparation

Trouble Shooting Guide

Manufacturer's Limited Warranty

Other Applicable Warranties

Information on separate warranties for engines and other component parts.

State Law and Warranty Rights

Explanation of how state laws affect consumer rights under this limited warranty.