How to fix a Yard-Man 500 that won't start?
If your Yard-Man Snow Blower engine won't start, make sure the choke is in the CHOKE position. Also, check that the spark plug wire is connected and the fuel tank isn't empty or filled with stale fuel. Ensure the engine is primed as instructed, the spark plug isn't faulty (clean, adjust gap, or replace if needed), and the key is fully inserted into the switch.
Why is my Yard-Man Snow Blower engine running erratically?
If your Yard-Man Snow Blower engine is running erratically, first ensure the choke lever is in the RUN position. Stale fuel could be the culprit; try filling the tank with clean, fresh gasoline. Also, check for water or dirt in the fuel system and drain/refill with fresh fuel. If these steps don't resolve the issue, the carburetor may be out of adjustment or the engine may be over-governed, and you should contact an authorized Service Center.
What to do if Yard-Man 500 fails to discharge snow?
If your Yard-Man Snow Blower fails to discharge snow, immediately stop the engine and disconnect the spark plug wire. Check for and remove any clogs in the chute assembly and any foreign objects lodged in the auger using a clean-out tool or stick. If these steps don't resolve the issue, refer to Auger Control Test, Maintenance & Adjustments section or replace shear pins.
Why is my Yard-Man 500 Snow Blower losing power?
If your Yard-Man Snow Blower is losing power, check the spark plug wire to ensure it is connected and tightened. Also, inspect the gas cap vent hole for any blockage from ice or snow, and clear it to ensure proper ventilation.
Why is my Yard-Man 500 vibrating so much?
If your Yard-Man Snow Blower is vibrating excessively, immediately stop the engine and disconnect the spark plug wire. Tighten all bolts and nuts. If the vibration continues, have the unit serviced by an authorized Service Center.
What causes a Yard-Man 500 engine to overheat?
If your Yard-Man Snow Blower engine overheats, the carburetor may not be adjusted properly. Contact an authorized Service Center.
Why won't my Yard-Man 500 Snow Blower move on its own?
If your Yard-Man Snow Blower fails to propel itself, you must adjust the drive control cable. If this does not solve the problem, you must replace the drive belt or friction wheel. Refer to Maintenance & Adjustments or Service section.
How to fix Yard-Man Snow Blower chute that won't rotate?
If the chute on your Yard-Man Snow Blower doesn't easily rotate 180 degrees, it might be assembled incorrectly. Disassemble the chute control and reassemble it as directed in the Assembly & Set-up section.
General| Type | Two-Stage |
|---|---|
| Number of Reverse Speeds | 2 |
| Auger Material | Steel |
| Engine Type | 4-Cycle |
| Starter Type | Electric Start |
To Next Page
