Page of 20
ASSEMBLY
All loose parts are shown on page 2. Hardware in the parts bag are shown on page 3.
Remove the hardware pack and all loose parts from the carton and verify that all the parts and
hardware shown on pages 2 and 3 are included.
Note: Right hand (R.H.) and left hand (L.H.) are determined from the operator’s position while seated
on the tractor.
(Figure 1) Assemble the angle bracket to the sweeper housing using a M8×16 hex bolt (F) and a Nylon
Lock Nut M8 (G). Make sure the bracket is turned as shown and aligned straight with the housing and
then tighten.
(Figure 2) Assemble the R.H. hitch tube to the sweeper housing using two M6 x 40 hex bolts (D), M6
nylon lock nuts (H). Do not tighten yet. Repeat for the L.H. hitch tube.
To Next Page
Loading...
