MAINTENANCE AND STORAGE
1. Never tamper with safety devices. Check
their proper operation regularly.
2. Disengage all clutch levers and stop en
-
gine. Wait until the auger/impeller come
to a complete stop. Disconnect the spark
plug wire and ground against the engine
to prevent unintended starting before
cleaning, repairing, or inspecting.
3. Check bolts, and screws for proper tight
-
ness at frequent intervals to keep the
machine in safe working condition. Also,
visually inspect machine for any damage.
4. Do not change the engine governor set
-
ting or over-speed the engine. The
governor controls the maximum safe op
-
erating speed of the engine.
5. Snow thrower shave plates and skid
shoes are subject to wear and damage.
For your safety protection, frequently
check all components and replace with
original equipment manufacturer’s
(O.E.M.) parts only. “Use of parts which
do not meet the original equipment spec
-
ifications may lead to improper
performance and compromise safety!”
6. Check clutch controls periodically to verify
they engage and disengage properly and
adjust, if necessary. Refer to the adjust
-
ment section in this operator’s manual for
instructions.
7. Maintain or replace safety and instruction
labels, as necessary.
8. Observe proper disposal laws and regula
-
tions for gas, oil, etc. to protect the
environment.
9. Prior to storing, run machine a few min
-
utes to clear snow from machine and
prevent freeze up of auger/impeller.
10. Never store the machine or fuel container
inside where there is an open flame,
spark or pilot light such as a water
heater, furnace, clothes dryer etc.
11. Always refer to the operator’s manual for
proper instructions on off-season storage.
4
To Next Page
