Yardbeast YB2090 - Stopping your engine; MAINTENANCE; General recommendations; Lubrication

Stopping your engine
1. Move the throttle lever
to the start
position, where it was in
the beg
position).
2. Turn the engine switch OFF
and close the
fuel access
; figures shown below
to the start
the beg
inning (slow
and close the
; figures shown below
.
MAINTENANCE
General recommendations
1. Always observe
safety rules when
performing maintenance.
2. The warranty on this
wood chipper
not cover items
that have been subjected
to wear,
misuse or negligence
operator. To receive
any warranty benefits;
the operator must have
maintain
equipment as indicated
in this
3. All settings (blade,
anvil, etc.
checked at least once
before each use
4. Periodically check all
bolts, nuts
pins, etc
for proper adjustment
WARNING
Stop the engine and
the spark plug
equipment.
Lubrication
1. Lubricate
the rotating elements
rotor, bearings
once a season
2. Follow
engine manual
lubrication instructions.
Wood Chipper Maintenance
Schedule Chart
Before each use
•Check power belts
• Check blade and anvil
Every 25 hours
•
Grease the bearing units.Nipples included
on each bearing housing.
• Regrind blade
• Regrind anvil
Engine Maintenance
15
:
safety rules when
wood chipper
, does
that have been subjected
misuse or negligence
of the
any warranty benefits;
maintain
ed the
in this
manual.
anvil, etc.
) should be
before each use
.
bolts, nuts
, safety
for proper adjustment
.
Stop the engine and
disconnect
before servicing
the rotating elements
such as
once a season
.
engine manual
for engine
Wood Chipper Maintenance
Grease the bearing units.Nipples included
on each bearing housing.