Yardbeast YB2090 User Manual

1. Turn the fuel valve to the ON
position and
the switch in the ON position. (If
equipped
See Fig 1 & 2 below.
1. Move the choke
control lever
choke position.
See Figure below .
position and
equipped
)
control lever
to the
3.Move the lever
throttle control
center position
between idle and fast
See the figure below.
4. Firmly hold the handle
of
pull the starter cord
slowly until
felt, then pull rapidly.
5 . If the
engine does not start
the previous three
steps until
6. Once the
engine starts to
the throttle lever
(choke
position.
7. If for some reason the
rotor
the engine loses power
but it doesn'
down, is because
this chipper is equipped
with a centrifugal clutch
that only engages
when it passes a certain amount of RPMs.
Turn off the engine (
as directed
check what is blocki
ng the rotor
rotating.
14
throttle control
to the
between idle and fast
.
of
the starter rope,
slowly until
resistance is
engine does not start
, repeat again
steps until
engine fires.
engine starts to
run, quickly turn
(choke
) to the RUN
rotor
stops spinning,
but it doesn'
t shut
this chipper is equipped
that only engages
when it passes a certain amount of RPMs.
as directed
below) and
ng the rotor
from

Yardbeast YB2090 Specifications

General

Brand	Yardbeast
Model	YB2090
Category	Other
Language	English