Need help?Do you have a question about the YardCraft POLY and is the answer not in the manual?
Identifies all components included in the assembly kit for the Poly Adirondack Dining Chair.
Details the necessary tools for assembly, including the included 5/32" Hex Key.
Fasten front legs to the seat using 1 1/2" bolts on a clean, smooth surface.
Fasten back legs to the seat using 1 1/2" bolts, noting one bolt is for back attachment.
Repeat leg attachment on the opposite side; do not fully tighten bolts yet.
Fasten armrests to front and back legs using 1 1/2" bolts in pre-drilled holes.
Tighten leg bolts, then thread 3" bolts into back leg empty holes (1/8" to 1/4" protrusion).
Align pre-drilled holes with inset nuts on the bottom of the back and tighten.
Fasten armrests to the center of the back using 2 1/4" bolts. Repeat on opposite side.
Assembly is complete. Verify the chair appearance matches the finished example.
General| Brand | YardCraft |
|---|---|
| Model | POLY |
| Category | Indoor Furnishing |
| Language | English |
To Next Page
