4
Note: the back leg only receives one bolt
into the inset nut at this point. The
through hole will be used to fasten the
bottom of the back. Tighten this bolt
when installing the back.
Begin by placing the seat on a clean,
smooth surface.
Fasten front legs to seat using 1 1/2" bolts
(front legs are legs with two inset nuts).
Fasten back leg to seat using 1 1/2" bolts.
Step:2
Step:3
Repeat steps 1 and 3 on opposite side
then your chair should look like this. Do
not tighten bolts yet.
Step:1
Step:4
To Next Page
Loading...