4
Prepare to install back by threading a
3" bolt into the empty hole on both
back legs. The bolt should only come
through a 1/8" to 1/4".
Fasten armrest to front and back leg
using 1 1/2" bolt. Arrows identify two
pre-drilled holes.
Tighten bolts. Then repeat steps 5 and 6
on opposite side. Tighten all bolts on
front leg.
Step:6
Step:7
Align pre-drilled holes with inset nuts
on bottom of back. Tighten.
Repeat on opposite side.
Step:5
Step:8
To Next Page
Loading...