37
3" (7,6 cm)
FRONT GABLE LADDERS
PARTS REQUIRED:
x4
x32
HINT:
Pre drill to avoid
x6
2 x 3 x 5-1/2" (5,1 x 7,6 x 14 cm)
URB
x2
2 x 6 x 3-5/8" (5,1 x 15,2 x 9,2 cm)
LUA
x2
2 x 6 x 5-1/4" (5,1 x 15,2 x 13,3 cm)
AYB
Screws
HPP
URB x3
Arrange, measure and mark locations of (3) URB as shown place HPP
on top. Secure with 3" screws as shown .
Ensure parts are ush along edges.
2
3
4
1
Flush
Flush
2-1/2"
(6,3 cm)
Flip over gable ladder sub-assembly and fasten
HPP to (3) URB with 3" screws .
Assemble AYB to LUA with (2) 3" screws .
Install L-block between HPP with (2) 3" screws in both
sides .
Pre-drill all holes.
Turn L-block so it is ush with corner angle of HPP.
Repeat steps to build the 2nd gable ladder.
HPP
Flush
Screws
2 x 3 x 83-13/16" (5,1 x 7,6 x 212,9 cm)
58"
(147, 3 c m)
28"
(71,1 cm)
2-3/4"
(7,0 cm)
83-13/16"
(212,9 cm)
3-5/8" (9,2 cm)
5-1/2"
(14 cm)
LUA
AYB
Screws
Flush
HPP
3/16" (4,8 mm) Drill Bit
To Next Page
Loading...