Yardworks 060-1723-0 User Manual

model number 060-1723-0 | contact us: 1.866.523.5218 model number 060-1723-0 | contact us: 1.866.523.5218
21
model number 060-1723-0 | contact us: 1.866.523.5218
TROUBLE SHOOTING
PROBLEM SOLUTION
1. Mower doesn’t run when
operation bail is activated.
Release switch lever to turn mower off. Remove safety key,
turn mower over and check that blade is free to turn. If not
free, return to an authorized servicer. Blade should turn freely.
2. Motor stops while
mowing.
A. Release switch lever to turn mower off. Remove safety key,
turn mower over and check that blade is free to turn. If not
free, return to an authorized servicer. Blade should turn freely.
B. Raise cutting height of wheels to highest position and start
mower.
C. Avoid overloading the mower. Slow down the cutting pace
by pushing mower slower or raise the cutting height. Or both.
3. Mower runs but
cutting performance is
unsatisfactory, or does
not cut entire lawn.
A. Release operating bail to turn mower off. Turn mower over
and check: Blade for sharpness - Keep blade sharp. Deck and
discharge chute for clogging.
B. Wheel height adjustment may be set too low for grass
condition. Raise cutting height.
4. Mower is too hard to
push.
A. Raise cutting height to reduce deck drag on grass. Check
each wheel for free rotation.
5. Mower is abnormally
noisy and vibrates.
A. Release operating bail to turn mower off. Turn mower
on side and check blade to ensure it has not been bent or
damaged. If blade is damaged, replace with a replacement
blade. If the underside of the deck is damaged return mower
to an Authorized service centre.
B. If there is no visible damage to the blade and the mower
still vibrates: Release switch lever to turn mower off, remove
blade. Rotate blade 180 degrees and retighten. If mower still
vibrates, return the mower to an authorized service centre.
6. Mower not picking up
clippings with the Grass
Collection Bag.
A. Remove mulch plate when bagging.
B. Chute clogged. Release operating bail to turn mower off.
Clear chute of grass clippings.
C. Too much cut grass. Raise cutting height of wheels to
shorten length of the cut.
D. Bag full. Empty bag more often.
7. When mulching there
are clippings visible.
A. Too much cut grass. Raise cutting height of wheels to
shorten length of the cut. Do not cut off more than 1/3 of total
blade length.
B. Check blade for sharpness. Always keep blade sharp.
Troubleshooting

Yardworks 060-1723-0 Specifications

General

Brand	Yardworks
Model	060-1723-0
Category	Lawn Mower
Language	English