Why is my Yardworks Log Splitter log pusher moving jerkily?
If the log pusher on your Yardworks Log Splitter moves jerkily, makes unusual noises, or vibrates excessively, it could be due to insufficient hydraulic oil and too much air in the hydraulic system. Check the oil level and refill if needed.
What to do if oil leaks from my Yardworks 060-3895-8 Log Splitter?
If you notice oil leaking from your Yardworks Log Splitter, it could be due to a few reasons. Air might have been sealed in the hydraulic system during operation, in which case you should loosen the bleed screw by 3 or 4 rotations before operating the log splitter. Ensure the bleed screw is tightened before moving the log splitter. Also, check if the oil drain bolt with dipstick is tight and tighten it if necessary.
Why does my Yardworks 060-3895-8 not split logs?
Your Yardworks Log Splitter might fail to split logs due to several reasons. Ensure the log is correctly positioned according to the operation instructions. The log's size or hardness might exceed the machine's capacity, requiring you to reduce its size. Check if the wedge cutting edge is blunt and needs sharpening. There may be an oil leak that needs to be located. An unauthorized adjustment to the maximum pressure limiting screw could also be the cause.
Identifies key parts like log pusher, work table, wedge, and motor.
Details on bleed screw, pressure limiting screw, and related warnings.
Specifies ambient temperature ranges and required electrical supply.
Explains the ZHB control system and safe operating positioning.
Advice on splitting hard logs and time limits for operation.
Proper log placement, grain direction, and avoiding forcing.
Step-by-step guide to safely remove a jammed log.
Procedure for replacing hydraulic oil every 150 hours.
Instructions on how to sharpen the splitter blade.
Explains symbols for operating, drugs/alcohol, and dangerous conditions.
Covers pre-operation inspection and appropriate attire.
Emphasizes wearing safety goggles to protect eyes from debris.
Guidelines for extension cords and avoiding electric shock.
Rules regarding visitors, log inspection, and not overreaching.
Warnings about hand safety, not forcing the tool, and unattended operation.
Procedures for disconnecting power and maintaining the splitter.
Advice on securing the workshop and storing the log splitter.
Outlines coverage, exclusions, and normal wear parts.
Instructions for warranty service and handling transportation charges.
General| Type | Electric |
|---|---|
| Splitting Force | 7 Tons |
| Maximum Log Diameter | 10 inches |
| Motor Power | 15 Amp |
| Maximum Log Length | 20.5 in (52 cm) |
| Warranty | 2 years limited |
To Next Page
