Yardworks 60-1772-2 - User Manual

Questions and Answers

E
Edward PhillipsAug 10, 2025
Why Yardworks 60-1772-2 won't start?
- U
  ubrownAug 10, 2025
  If your Yardworks Lawn Mower doesn't start, there are several potential causes: * The power cord might be disconnected from the switch. Reconnect it, ensuring you use the cord restraint to keep it secure. * The extension cord may not be properly connected to either the mower plug or the power source. Ensure it's firmly connected to both a live 120 V AC 60 Hz outlet and the mower plug. * A defective motor/blade control switch could also be the culprit, requiring a replacement of the switch. * Check if the circuit breaker in your house has tripped. Reset it, but if it trips again, it's best to consult a qualified electrician.
J
Jesse ShortAug 15, 2025
Why is my Yardworks 60-1772-2 hard to push?
- T
  Teresa MartinAug 16, 2025
  If your Yardworks Lawn Mower is hard to push, it could be due to a few reasons. The grass might be too long, or the cutting height is set too low. Also, the rear of the mower housing and the blade might be dragging in heavy grass. To resolve this, try raising the cutting height.
M
Michael AndersonAug 21, 2025
How to fix Yardworks Lawn Mower cutting grass unevenly?
- R
  Ronald JohnsonAug 21, 2025
  If your Yardworks Lawn Mower cuts the grass unevenly, the lawn may be rough or uneven. Check the mowing area. Alternatively, the cutting height may not be set properly. Move the wheels to a higher position.
P
phillip55Aug 25, 2025
What to do if Yardworks 60-1772-2 Lawn Mower vibrates at higher speed?
- F
  Faith WoodAug 26, 2025
  If your Yardworks Lawn Mower vibrates at higher speeds, the motor shaft might be bent, or the blade could be unbalanced. In the first case, stop the motor, disconnect the mower from the power source, and inspect it for damage. Repair the mower before restarting. In the second case, balance the blade by grinding each cutting edge equally.
M
Miss Allison HodgesAug 30, 2025
What to do if Yardworks 60-1772-2 Lawn Mower is not mulching properly?
- S
  Shelly SimpsonAug 30, 2025
  If your Yardworks Lawn Mower is not mulching properly, it could be because wet grass clippings are sticking to the underside of the deck. The solution is to wait until the grass dries before mowing.
W
William BellSep 4, 2025
How to adjust handle position on Yardworks Lawn Mower?
- J
  jessicaguerreroSep 4, 2025
  If the handle of your Yardworks Lawn Mower is not in position, it might be related to the carriage bolts. Adjust the height of the handle and verify that the carriage bolts are properly seated. Then, tighten the knobs.