Yardworks 60-1750-4 - User Manual

Questions and Answers

J
Julia GreerAug 1, 2025
What to do if my Yardworks 60-1750-4 Lawn Mower does not start?
- C
  callahanrebeccaAug 1, 2025
  If your Yardworks Lawn Mower doesn't start, there are several potential causes: * Ensure the power cord is securely connected to the switch, using the cord restraint to keep it in place. * Verify the extension cord is properly connected to the mower plug. * Confirm the extension cord is connected to a working 120 V AC 60 Hz outlet. * Check if the circuit breaker in your house has tripped and reset it. If it continues to trip, it's best to consult a qualified electrician. * The switch might be defective and needs replacement.
X
xhernandezAug 6, 2025
How to fix uneven grass cutting with my Yardworks 60-1750-4 Lawn Mower?
- V
  vargaskatherineAug 6, 2025
  If your Yardworks Lawn Mower cuts grass unevenly, it could be due to a rough or uneven lawn. Check the mowing area for any irregularities. Also, ensure that the cutting height is properly set; try moving the wheels to a higher setting.
C
Casey RojasAug 10, 2025
How to adjust the handle position on my Yardworks 60-1750-4 Lawn Mower?
- J
  Joseph JohnsonAug 11, 2025
  To adjust the handle position on your Yardworks Lawn Mower, adjust the height of the handle and make sure that the carriage bolts are properly seated in the handle insulators.
B
brucestaffordAug 16, 2025
Why does my Yardworks 60-1750-4 Lawn Mower vibrate at higher speed?
- J
  Jocelyn HartAug 16, 2025
  If your Yardworks lawn mower vibrates at a higher speed, it could be due to a bent motor shaft or an unbalanced blade. Immediately stop the motor, disconnect the mower from the power source, and carefully inspect it for any signs of damage. Balance the blade by grinding each cutting edge equally. If the vibration continues after these steps, repair the mower before restarting.
T
Timothy BryantAug 20, 2025
Why is my Yardworks Lawn Mower hard to push?
- E
  eloweAug 21, 2025
  If your Yardworks Lawn Mower is hard to push, it might be because the grass is too long, or the cutting height is set too low. Try raising the cutting height to make it easier to push.
L
Laura HouseAug 26, 2025
Why is my Yardworks Lawn Mower not mulching properly?
- A
  Alex HowardAug 26, 2025
  If your Yardworks Lawn Mower isn't mulching properly, it's likely due to wet grass clippings sticking to the underside of the deck. Wait until the grass dries before mowing to resolve this issue.