Yardworks 622019-1 User Manual

TROUBLESHOOTING
17
Model 622019-1
Problem Possible cause Solution
The mower fails to start The safety key is not inserted in the slot.
The battery packs are depleted.
The battery packs are not attached to the
mower.
The battery packs are on the wrong side.
Battery or mower circuitry is too hot.
The handle is not set at one of the
operating positions.
Mower deck is clogged with grass and
debris.
Insert the safety key.
Charge the battery packs.
Attach the battery packs to the mower.
Move the battery packs to the correct side of
the battery compartment.
Allow the battery packs or mower to cool
down.
Adjust the handle to the one of the operating
positions.
Clean the mower deck and make certain that
the blade has freedom of movement.
The mower cuts unevenly. Dull blade.
The cutting height is not set properly.
The blade is assembled incorrectly.
Sharpen or replace blade.
Raise the blade to a higher setting.
Reassemble the blade, following the section
"Replacing the Cutting Blade" in this manual.
Mower stops while
mowing.
The battery packs are depleted.
Mower is in overload condition.
Mower deck is clogged with grass and
debris.
Battery or mower circuitry is too hot.
Charge the battery packs.
Raise cutting height or slow down the mowing.
Unclog mower deck. Raise cutting height, or
cut a narrow swath.
Allow the battery packs or mower to cool
down.
Mower does not mulch
properly.
Wet grass clippings are sticking to the
underside of the deck.
Mulching plug is missing.
The mower is set to cut too much grass.
Wait until the grass dries before mowing.
Install the mulching plug.
Raise the blade to a higher setting.
Excessive vibration Cutting blade is loose.
Cutting blade is unbalanced.
Bent cutting blade.
Bent motor shaft.
Tighten the blade bolt as shown in figure 12.
Balance the blade as shown in figure 14.
Replace the blade as shown in figure 12 & 13.
Contact the service center at 1-800-633-1501.
Handle not in position Carriage bolts not seated properly.
Handle knobs not tightened.
Adjust the height of the handle and make sure
the carriage bolts are seated properly.
Tighten handle knobs.

Yardworks 622019-1 Specifications

General

Brand	Yardworks
Model	622019-1
Category	Lawn Mower
Language	English