model no. 060-1984-8 | contact us: 1.866.523.5218model no. 060-1984-8 | contact us: 1.866.523.5218
12
3. Assembling the safety guard
Attach the safety guard to the trimmer head. Align the guard so it slides into the slots
located on the trimmer head (see Fig. C1.).
Secure the safety guard onto the trimmer head with the screw provided (see Fig. C2.).
BEFORE OPERATION
1.CHARGING THE BATTERY PACK
IMPORTANT NOTES FOR CHARGING BATTERY
The battery in your new tool is not charged when it leaves the plant; therefore, it must be fully charged
before using the rst time.
NOTE: If the battery pack is very hot, remove the battery from the charger and allow it to cool to
ambient temperature before attempting to recharge.
To prevent damage to the battery pack, please charge the battery to full or no less than half charge
before storage.
If the tool will not be used for long periods of time, charge the battery every 3-6 months.
CHARGING PROCEDURE (SEE FIG. D)
1) Plug the charger into an appropriate outlet.
2) Slide the battery pack into the charger; the light will begin ashing green to indicate the charging
process has started.
3) When charging is completed, the light will turn solid green. The pack is now fully charged; unplug
the charger and remove the battery pack.
WARNING:
When battery charge runs out after continuous use or exposure to
direct sunlight or heat, allow time for the tool to cool down before re-charging
to achieve the full charge.
Operation
A2
A1
C2
C1
B
E1
E2
G
F
H2
H1
H4
H3
J1
I
J3
J2
K2
J4
K1
LOW
High
1
2
1
2
1
2
14
15
30
0
1
2
3
2
1
To Next Page
Loading...
Need help?
General