The available Wi-Fi networks appear in the network list at the right screen. Tap the network of
your choice. If the network is secured, you’re prompted to enter the network security key.
Press the “Connect” button and the GoTab is connecting to the network.
Once “Connected” appears underneath the network name and the wireless reception icon is
shown in the bottom status bar, you’re successfully connected to the wireless network.
Viewing your Yarvik GoTab's Wi-Fi MAC address
While in the Wi-Fi settings screen, click on the menu button in the top right corner.
Press "Advanced" in the unfolding menu.
Your Wi-Fi MAC address is displayed in the following "Advanced Wi-Fi" screen under "MAC
address".
Bluetooth
Your Yarvik GoTab tablet is equipped with a built-in Bluetooth module for connecting with
Bluetooth compatible peripherals, like mice, keyboards, speakers and headphones.
Slide the Bluetooth On/Off button to "On" to activate Bluetooth.
Once activated, your Yarvik GoTab tablet will automatically start searching for nearby Bluetooth
devices. You can always manually search for Bluetooth devices by clicking "Search for Devices"
in the top right corner of the screen.
It may be required for the to be connected peripherals to be put in "pairing mode". Please refer
to the instructions manual of the concerning peripherals for this.
All discovered devices will appear in the "Available Devices" list:
To Next Page
Loading...
Need help?
General
