1. Sampling Port: apply the blood to either
side of strip.
2. Detection Zone: make sure the part is
filled up with blood to ensure the correct
results.
For example:
3. Electrode End: insert the end of test strip
into meter.
IMPORTANT INFORMATION
1. Do not use damaged test strips or test strips
changed in any way. Use test strip immediately
after removing it from the vial. Recap the vial
immediately and close it tightly.
2. GLS-77 Blood Glucose Test Strips are intended
for in vitro diagnostic use with capillary whole
blood or control solution. Results will not be
accurate if used with plasma or serum samples.
3. GLS-77 Blood Glucose Test Strip can be
damaged by heat and light. Keep them sealed
in the original vial. Keep the vial in a cool, dry
place below to 30℃/86℉and above 5℃/41℉.
4. Do not refrigerate.
5. Do not use test strips beyond the expiration
date indicated on the vial. The discard date for
test strips is three (3) months after first
opening the vial. Record the discard date on
the vial, when you open a new one.
6. For single use only.
7. Do not carry loose test strips in your carrying
case.
GLS-77 BLOOD GLUCOSE TEST STRIP
6
To Next Page
Loading...