Overexposure Only the red ( + ) LED turns on. It means your subject is too bright. Stop down the aperture or
use a faster shutter speed to turn on the green LED.
Underexposure Only the red (-) LED turns on. It means your subject is too dark. Open up the aperture or use a
slower shutter speed to turn on the green LED.
ired
ject. While looking through the viewfinder, turn the Focusing Ring to
iewfinder. If it turns on, take your picture by pressing the Shutter Release Button all the way in.
TAKING PICTURES
1. Set the shutter speed and aperture. 1 Turn the Shutter Speed Dial and Aperture Ring and set your des
values.
2. Focus the lens and frame your sub
focus and compose your picture.
Check the exposure and shoot. ~ Press the Shutter Release Button halfway in and check if the green LED turns
on in the v
<Exposure Meter Coupling Range> The following chart shows the shutter speeds that are usable at different
ASA speeds.
To Next Page
Loading...
