8
1. Please use the power adapter provided by Yealink to get a more efcient charging ex-
perience.
2. Please do not place any metal and magnetic cards on the charging board to avoid
abnormalities and damage to the charger.
3. Please do not charge too far away from the charging sign to get a more efficient
charging experience.
4. During use, if you nd the charging board or the charged device is overheated and the
charging stops (the indicator light keeps ashing), you need to remove the charged
device until it cools down, and then try charging again.
5. The indicator light of the charging stand keeps ashing, and it may be the following
three situations:
• The location of the charged device is not placed correctly. You need to replace the it.
After calibrating the charging position, you can charge the device normally until the
indicator light is always on.
• The charging stand has an overheating alarm. After the mobile phone or the charging
stand cools down, it will stop ashing automatically and enter the normal charging
state.
• Metal or magnetic cards may be placed on the charging board, and please remove
them.
Notes for BHC76 (optional)
Safety Guide for BHC76 (optional)
1. Do not disassemble the product by yourself or bring it near re and water to avoid
short circuit leakage or damage to the product.
2. Do not use the product in high temperature, humidity, and corrosive environment to
avoid damaging the circuit and causing failure to charge or other failures.
3. Do not expose the product to corrosive liquids. Otherwise, it will cause severe damage.
4. Do not disassemble or re-equip the product for any reason to avoid secondary failure
and burnout.
5. Do not place the product below -10°C or above 60°C.
6. Do not knock, throw or shake the product because rough methods will damage the
internal circuit board structure.
If you need to know the product warranty information, please visit
https://ams.yealink.com.
To Next Page
Loading...
Need help?
General
