Yealink RT30 User Manual

www.yealink.com
4
Star setup:
Up to 6 repeaters can be registered to one base station to extend the range
in a star layout. All repeaters must be installed within the base station
coverage, as shown in the figure below.
Registration
If you want to register more than one repeater, in order to avoid ID conflict,
we recommend that you put the repeaters closer to the base station and
register the repeaters one by one.
1. Plug the repeater into an AC outlet.
POWER LED turns green and DECT LED flashes red.
2. Set the handset in RT30 repeater mode at the path: Settings->System
Settings->Repeater Mode.
3. Set the base station in registration mode (Long press the paging key on
the base station till the first LED flashes green).
If base station is found, DECT LED will flash orange.
When DECT LED turns green/orange, the registration to base station is
successful.
Cascade Registration
Up to 2 repeaters can be registered to the base station in a cascade setup.
Registering the Repeater
50m/300m
RT30
RT30
RT30
RT30
RT30
RT30
W60B

Yealink RT30 Specifications

General

RF power	10 mW
LED indicators	Activity, Network, Power
Wall mountable	Yes
Frequency range (EU)	1880 - 1900 MHz
Frequency range (US)	1920 - 1930 MHz
Maximum indoor range	50 m
Maximum outdoor range	300 m
Radio Frequency (RF) range	- MHz
AC input voltage	100 - 240 V
DC output current	0.6 A
DC output voltage	5 V

Weight and Dimensions

Depth	25.1 mm
Width	130 mm
Height	100 mm
Weight	3200 g