Yealink RT30 User Manual

5
DECT Repeater RT30 User Guide
Before the cascade registration, you should first register the two repeaters
to the base station. For cascade registration, we recommend that you put
the two cascaded repeaters closer to each other. One repeater attempts
to register to the other repeater (destination repeater). If the destination
repeater de-registers, the repeater does as well. Conversely, it does not.
The repeater supports automatic or manual cascade registration.
Auto Cascade Registration
1. Long press the program key on one repeater for about 3 seconds.
The repeater starts searching for the other repeater, POWER LED turns
orange and DECT LED flashes green.
Wait until POWER LED turns green and DECT LED turns green/orange, auto
cascade registration is successful.
Manual Cascade Registration
1. On one repeater:
a. Confirm the ID: Press the program key. The number of times that RELAY
LED flashes indicates the ID. Press the program key again to return to
the operation mode.
2. On the other repeater:
a. Long press the program key for about 3 seconds.
b. Press the program key as soon as POWER LED turns orange and DECT
LED flashes green, to enter the repeater's ID to be cascaded. Pressing
once indicates that the ID is 1.
POWER LED turns orange and DECT LED turns green.
c. Press the program key for about 3 seconds to confirm the ID.
The repeater starts searching for the repeater to be cascaded, POWER
LED turns green and DECT LED flashes orange.
Wait until POWER LED turns green and DECT LED turns green/orange,
manual cascade registration is successful.
ID Modification
After registering to the base station, every repeater has its own ID, it uses ID
to distinguish with each other. If the IDs of two repeaters conflict, you need
to modify the ID manually.
1. Press the program key to confirm the ID.
2. Long press the program key for about 7 seconds to enter the ID
modification mode.
Both POWER LED and DECT LED turns red.
3. Press the program key to enter the new ID. Pressing once indicates that
the ID is 1.
The number of times that the RELAY LED flashes indicates the entered ID.
4. Long press the program key for about 3 seconds to confirm the ID.
The repeater will re-register.

Yealink RT30 Specifications

General

RF power	10 mW
LED indicators	Activity, Network, Power
Wall mountable	Yes
Frequency range (EU)	1880 - 1900 MHz
Frequency range (US)	1920 - 1930 MHz
Maximum indoor range	50 m
Maximum outdoor range	300 m
Radio Frequency (RF) range	- MHz
AC input voltage	100 - 240 V
DC output current	0.6 A
DC output voltage	5 V

Weight and Dimensions

Depth	25.1 mm
Width	130 mm
Height	100 mm
Weight	3200 g