4
EN
plug the OMNI Station.
32. WARNING: For the purposes of recharging
the battery, only use the detachable supply
unit CH2251 provided with the Appliance.
To satisfy RF exposure requirements, a separation distance
of 20 cm or more should be maintained between this
device and persons during device operation.
To ensure compliance, operations at closer than this
distance is not recommended. The antenna used for this
transmitter must not be co-located in conjunction with any
other antenna or transmitter.
To disable Wi-Fi module on Robot, power the Robot ON.
Place the Robot on the Charging Station making sure the
Charging Contacts on Robot and the Charging Station
Pins make a connection.
Press and hold the SPOT Button on the Robot for 20
seconds until Robot emits 1 beep.
To enable Wi-Fi module on Robot, power the Robot OFF
and then power ON. The Wi- Fi module is turned on when
Robot is restarted.
24. Remove the Appliance from the OMNI
Station, and turn OFF the power switch to
the Appliance before removing the battery
for disposal of the Appliance.
25. The battery must be removed and discarded
according to local laws and regulations before
disposal of the Appliance.
26. Please dispose of used batteries according
to local laws and regulations.
27. Do not incinerate the Appliance even if it
is severely damaged. The batteries can
explode in a re.
28. When not using the OMNI Station for a long
period of time, please unplug it.
29. The Appliance must be used in accordance
with the directions in this Instruction Manual.
The manufacturer cannot be held liable or
responsible for any damages or injuries
caused by improper use.
30. The Robot contains batteries that are only
replaceable by skilled persons. To replace
the Robot’s battery, please contact Customer
Service.
31. If the Robot will not be used for a long time,
power OFF the Robot for storage and un-
To Next Page
Loading...
Need help?
General
