IMPORTANT
1. Please check and clean the Stainless Steel Strainer/HEPA regularly.
2. Please clean the filter in time if the suction performance decline.
3. Please replace the filter/HEPA if it is broken or it cannot maintain
the suction performance of the vacuum cleaner.
4. Please do not bend or squeeze the HEPA.
Filter Installation
1. Detach the main motor and dust cup, take out the HEPA in the main motor and the
filter component in the dust cup. Hold the strainer, rotate the filter holder, then take
out the sponge filter.
2. If they are too dirty, you could wash the strainer and the sponge with cool water, and
clean the HEPA with the cleaning brush.
3. Ensure the strainer and sponge are completely dry before refitting.
90°
03. Make sure the NOTCH on the filter
holder fits into the slot perfectly.
04. Make sure the strainer keeps vertical
to the dust cup cover.
05. Put the HEPA filter into the
main motor.
01. Put the sponge into the strainer. 02. Lock the strainer to the filter holder.
06. Connect the dust cup to the
main motor.
To Next Page
Loading...
