ENGLISH
32
DEVICE ASSEMBLY
1. Take the product out of the packaging and take off the poly-bag.
2. Put together the two halves of the base at a slight angle so as to fit the connecting insets to
the grooves.
3. Connect the two parts so that the connecting insets are fully inserted into the grooves. Push
them in until they are evenly joined.
4. Thread the power cord through the cutout on the fan’s body and put the assembled base
onto the device. The power cord should be visible through the opening on the
base. Make sure it goes through the cutout on the base.
5. Install the base using the four wing nuts.
To Next Page
Loading...
Need help?
General
