Appendix1.Defaultconguration
App.1-2
TI 30A10A30-01E
For more information of the default configuration, the example of “show running-config” display is
shown below. In the list, those blank or repeating lines are omitted.
RS40(L2SW)familydefaultconfiguration
Therunning-configonRS40(LS2W)familydefaultconfiguration(1/2)
F0A0101.ai
(Hirschmann Railswitch) #show running-config
!Current Configuration:
!Customized factory setting active
!
!Parameter string escape handling \, 1
!Characters to be preceded with escape char (\): \, !, ", ', ?
!System Description "Hirschmann Railswitch"
!System Version L2P-06.0.01 Build: 2010-09-24 18:18
vlan database
exit
network protocol none
network protocol hidiscovery off
!RMA operation
!RMA entry
configure
!
interface 1/1
exit
interface 1/2
exit
(Snip) interface 1/3 to 1/8 --- repeating the same setting.
interface 1/9
exit
!Address Conflict Detection
!Bridge Address Learning
!Bridge Fast Link Detection
!Maximum size of frame (packet size)
!Bridge Address Relearn Detection
!Bridge Address Relearn Threshold
!Bridge Duplex Mismatch Detection
!Service Mode
!VLAN Learning
!Hirschmann DHCP Relay
!Hirschmann Device Status
!DHCP Server
!DHCP Server pools
!Ethernet/IP
!Power over Ethernet (IEEE 802.3af)
!Selftest
selftest ramtest disable
Sep. 19, 2014-00