Need help?Do you have a question about the Yokomo Factory B-MAX4 and is the answer not in the manual?
General| Scale | 1/10 |
|---|---|
| Width | 248mm |
| Drive Type | 4WD |
| Shock Type | Oil-filled |
| Motor | 540-size |
| Body | Polycarbonate |
| Tire Type | Not included |
| Kit Type | Assembly Kit |
Key safety and assembly tips for building the R/C car.
Safety guidelines for operating the R/C car, including starting and stopping procedures.
Important safety and handling instructions for R/C car batteries.
Guidelines for safe operation and maintenance of the R/C car motor.
Essential components to purchase separately for operating the R/C car.
Tools that are needed for assembly but not included in the kit.
Tools that are provided within the R/C car kit for assembly.
Detailed steps for assembling the front and rear shock absorbers.
Instructions on filling shock oil and removing air bubbles.
Inventory of components used for shock assembly.
Detailed instructions for attaching the assembled front shock absorbers to the chassis.
Detailed instructions for attaching the assembled rear shock absorbers to the chassis.
Inventory of components used for shock installation.
Guide for installing the battery holder and pads on the R/C car chassis.
Instructions for applying foam tape to the chassis for battery stability.
Details on fitting different types of battery packs.
Inventory of components used for battery holder installation.
Steps for mounting the motor and adjusting gear mesh.
How to attach and secure the pinion gear to the motor shaft.
Critical procedure for setting gear mesh clearance to prevent damage.
List of suitable pinion gear sizes for the motor.
How to center the servo, attach the horn, and install mounts.
Steps for securely mounting the receiver and speed controller.
Instructions for installing the antenna mount, tube, and cap.
Inventory of components used for mounting electronics.
How to mount tires onto wheels and secure them with glue.
Steps for assembling front and rear tires and wheels.
Instructions for attaching the assembled wheels to the car's hub.
Inventory of components used for tire and wheel mounting.
Steps for assembling and attaching the rear sway bar system.
How to adjust the sway bar set screws for smooth operation.
Inventory of components used for rear sway bar installation.
Instructions for cutting the R/C car body along the designated lines.
Guidance on cutting the R/C car wing according to preference.
Suggestions for specialized tools to aid in body and wing preparation.
Inventory of components used for body and wing preparation.
How to wash and mask the body before applying paint.
Guidelines for applying spray paint evenly and in multiple coats.
Step-by-step instructions for applying decals to the painted body.
Inventory of components used for body painting and decal application.
Instructions for attaching the R/C car body using Velcro tape and clips.
Steps for securing the R/C car wing to the body.
Inventory of components used for body and wing installation.
How to adjust the ball differential for optimal performance and handling.
Crucial safety warning to turn off the speed controller before adjustments.
Step-by-step guide for adjusting the ball differential.
How to adjust the slipper clutch for proper torque transfer.
Detailed steps for adjusting the slipper clutch.
Options for configuring the R/C car setup based on circuit conditions.
Settings for the front suspension, including toe-in and shock oil.
Settings for the rear suspension, including toe-in and shock oil.
Configuration options for spur, pinion, motor, battery, and ESC.
Options for selecting front and rear tires, inserts, and wheels.
Various circuit condition settings like traction and surface type.
Detailed adjustments for front toe-in, shock oil, and springs.
Detailed adjustments for rear toe-in, shock oil, and springs.
Settings for spur, pinion, motor brushes, battery, and ESC.
Options for front and rear tire, insert, and wheel selection.
To Next Page
