4
FOAM BUMPER INSTRUCTION
Use scissors to cut out the
template as shown
Use an ink marker to
outline the trimming area.
Cut into the foam bumper
using a sharp hobby knife
and follow the outline. Try
to cut into the bumper as
straight as possible.
Follow the outline and
make sure you have cut
deep enough to remove all
of the unwanted material
from the bumper.
The bumper is now
trimmed and there is
enough room for the body
to be mounted properly.
In order for the included body to t
properly over the front foam bumper, a
portion of the bumper must be trimmed
away. Cut out the foam bumper template
below and follow the steps shown on the
left. Scissors, a sharp hobby knife and an
ink marker will be required to complete
the steps.
To Next Page
Loading...
