Yokota WU-1 - Error Handling and Bolt Control

76-QD7913EN-00Y00-03.doc
23
SLOW ER NO.
Set contents
Selection
Default
Setting slow error number.
10～50
20
COMPEMC NUM.
Set contents
Selection
Default
Setting compensation number.
Torque is also measured throughout compensation number.
0～5
0
FREERUNNING NG STOP
Set contents
Selection
Default
Setting ON/OFF of free-running NG stop.
ON: In the event of free-running angle NG, the tool stops.
OFF: In the event of free-running angle NG, the tool does not stop.
OFF
ON
OFF
FINAL ANG. NG STOP
Set contents
Selection
Default
Setting ON/OFF of final angle NG stop.
ON: In the event of final angle NG, the tool stop.
OFF: In the event of final angle NG, the tool does not stop.
OFF
ON
OFF
BOLT NUMBER
Set contents
Selection
Default
Setting bolt number under quantity control.
0～99
2