Yokota WU-1 - Relay Output Timing Settings

76-QD7913EN-00Y00-03.doc
25
7.2.2.1. RELAY TIME
WORK FIN
Set contents
Selection
Default
Setting work finish output time.
If 0,0 is selected, outputting is continued.
0.0～9.9(s)
0.0
WORK SEL
Set contents
Selection
Default
Setting work select output time.
If 0,0 is selected, outputting is continued.
0.0～9.9(s)
0.0
COUNT NG
Set contents
Selection
Default
Setting count NG output time.
If 0,0 is selected, outputting is continued.
0.0～9.9(s)
0.0
OK
Set contents
Selection
Default
Setting OK output time.
If 0,0 is selected, outputting is continued.
0.0～9.9(s)
0.0
OVER
Set contents
Selection
Default
Setting OVER output time.
If 0,0 is selected, outputting is continued.
0.0～9.9(s)
0.0
OTHER RY
Set contents
Selection
Default
Setting other signal output time.
If 0,0 is selected, outputting is continued.
0.0～9.9(s)
0.0