6
11. Deleting all transmitters
12. Activation of impulse mode
13. Controlling with the application
The motor will make a sound.
The blind will make short
up/down moves.
The motor will make
a sound. The blind
will make short
up/down moves.
The blind will make
two short up/down moves.
The motor will make a few
short sound signals.
Press
STOP button.
Press P2
programming
button.
Press P2 programming
button on remote control A.
All active transmitters
have been deleted.
1. A break between succesive button presses longer than 6 seconds, will automatically cause the exit from programming
mode without saving the changes.
2. To turn on the impulse mode, follow the procedure below and to turn it off - repeat the same procedure.
3. The impluse function is carried out in the following way: short pressing of UP or down button causes fluctuating motor
operation and holding the button for more than 2 seconds causes steady motor operation.
The blind will make short
up/down moves.
Press and hold
UP and DOWN buttons
simultaneously
for 5 seconds.
Place the motor in the
upper limit position.
Press and hold UP and
STOP buttons
simultaneously
for 2 seconds.
The motor will make a move in
the direction of the lower limit
position, then in the direction of
the upper limit position.
The blind will make short moves
in both directions, confirming
that limit positions have been
programmed.
Press STOP button
on the remote control.
If the blind makes a short
move in both directions and
the motor makes a sound,
impulse mode is ON.
If the blind makes two short
moves in both directions and
the motor makes a sound
three times, impulse
mode is OFF.
To percentage control the roller blind positions, you must programme upper and lower limit positions.
To Previous Page
Loading...
Need help?
General
