YOODA ARTISTIC-1R User Manual

1. Estimated battery lifespan is 3 year if the device runs 4 commends a day in average.
2. Batteries should be changed when LED diode stops flashing when channel is being changed or receiving device stops
reacting to commands.
3. When placing the battery ensure that polarity is correct.
4. Choosing ‘00’ group channel means remote controls all programmed devices on all channels at the same time. No
programming
functions can be performed on group channel. All devices programmed to any other channel can be controlled on group
channel without additional programming.
Batteries contain substances that may be hazardous to health and may pollute the environment. Used batteries should
be disposed of properly.
UP button
current
channel
STOP button
P2
programming button
battery
DOWN button
Single-channel transmitter
(front)
5-channel transmitter
(front)
Single-channel or 5-channel transmitter
(back)
UP button
PREVIOUS CHANNEL
button
DOWN button
NEXT CHANNEL
button
STOP button
1. Way of programming first transmitter depends on type of radio receiver. When programming first transmitter please
follow instruction of the device that is going to be controlled by the transmitter.
2. Longer than 5 seconds pause between series of button clicks during programming will cause device to switch off from
programming mode without saving any changes.
3. Programming transmitter using this ethod will result in deleting receiver memory.
Turn on power supply or press
microswitch (for 2 sec.) when
power is on.
Motor will make a sound.
Roller shutter will make
an up/down move.
Motor will
make a sound.
Press
programming button
(P2) on the remote.
or
Roller shutter
will make
an up/down move
and the motor will
make
a few short sounds.
Motor will
make a sound.
Press
programming button
(P2) on the remote.
Press
UP button
on the remote.
2
Pressing UP or DOWN button exits active channel selection mode.
Repeat the following procedure to set the number of active channels.
3. Active channel selection
4. Programming first transmitter to R-type motors
Press simultaneously and hold down the CHANNEL +
and CHANNEL- buttons. "C" symbol appears on the
display and than after 4 seconds it changes
to number 15 with up and down arrows.
Use the CHANNEL + or CHANNEL -buttons
to set the number of displayed channels.
Press the STOP key to conrm your choice.
The symbol "o" should appear.

YOODA ARTISTIC-1R Specifications

General

Brand	YOODA
Model	ARTISTIC-1R
Category	Remote Control
Language	English