York R91/BGE - Automatic Operation; Starting Automatic Operation; Stopping Automatic Operation

1
2
3
SET TEMPERATURE ( )
AUTO
COOL
DRY
HE AT
FA N
HIGH
MED
LO W
MODE FA N SPEED ON/ OFF
SWI N G
AI R
DIRECTION
TIMER ON TIMER OFF
LE D
DISPLA
Y
TURBO
SL EEP
RESE T L O C K
TEMP
Automatic operation
When you set the air conditioner in AUTO mode,
it will automatically select cooling, heating
(cooling only type without), or fan only operation
depending on what t emperat ure you have
select ed and t he room t emperature.
Once you select t he operating mode, the
operating conditions are saved in the unit’s
microcomputer memory.
Thereaft er, the air conditioner will start operating
un der t he sam e con di t i on s wh en you si mp l y p ush
the ON/OFF button of the remote controller.
St a r t
Ensure the unit is plugged in and power is
available. The OPERATION indicat or on t he
disp l ay p an el of t h e ind o or un i t st art s ash i n g.
1. Mode select button (MODE)
Pr ess t o sel ect AUTO.
2. Temperature but ton (TEMP)
Set the desired temperature. Normally, set it
between 21 °C to 2 8 °C
3. ON/ OFF b u t t on
When the remote controller is o, push this
button to start the air conditioner.
St o p
ON/ OFF b ut t on
Push this button again to stop the air conditioner.
If the AUTO mode is uncomfortable, you can
select the desired conditions manually.
When you select t he AUTO mode, you do not
have t o set t he fan speed. The fan speed will be
automatically controlled.
5
BY JOHNSON CONTROLS