York YEHJZH009-24BAM1ABX - Installation of Indoor Unit; Choosing Installation Location; Wall Mounting Frame Installation; Piping Hole Preparation

26
Step one: choosing installation location
Step two: install wall-mounting frame
rm it with the client.
1. Hang the wall-mounting frame on the wall; adjust it in horizontal position with the
plastic expansion particles in the holes.
3. Fix the wall-mounting frame on the wall with tapping screws (ST4.2X25TA) and
.
1. Choose the position of piping hole according to the direction of outlet pipe. The
position of piping hole should be a little lower than the wall-mounted frame,
shown as below.
Step three: open piping hole
2. Open a piping hole with the diameter
Note: Please select the corresponding installation dimensional drawing ac-
cording to actual wall-mounted plate.
oIĭRQWKHVHOHFWHGRXWOHWSLSH
position. In order to drain smoothly, slant the piping hole on the wall slightly
GRZQZDUGWRWKHRXWGRRUVLGHZLWKWKHJUDGLHQWRI
Installation of indoor unit
、、 12K
24K
18K
Left
Wall
ĭPP
Right
Mark in the middle of it
Level meter
Rear piping hole
Wall
Space
to the
wall
above
PP
Space
to the
wall
above
PP
ĭPP
Rear piping hole
Left
Wall
ĭPP
Right
Mark in the middle of it
Level meter
Rear piping hole
Wall
Space
to the
wall
above
PP
Space
to the
wall
above
PP
ĭPP
Rear piping hole
Left
Wall
ĭPP
Right
Mark in the middle of it
Level meter
Rear piping hole
Wall
Space
to the
wall
above
PP
Space
to the
wall
above
PP
ĭPP
Rear piping hole